Home About
Home About
Twitter
RSS

Archive for the ‘Air Conditioning’ Category

« Older Entries
Newer Entries »

HVAC Heat Pumps 2

By on Thursday, December 10th, 2009 | 25 Comments

I show how to do some basic troubleshooting on a heat pump defrost board. Please visit Becky’s channel at: www.youtube.com

Read More...

How much does it cost to have a repair man look at my furnace?

By on Thursday, December 10th, 2009 | 4 Comments

I lie in a mobile home and my furnace doesn’t work. The pilot light comes on but the burner doesnt lite. I think it is my gas valve. I looked them up on the internet and found that they are around $200.00 but couldn’t find the exact one for my furnace. How much would it [...]

Read More...

HVAC system, How do i measure the existing air exchange rate?

By on Thursday, December 10th, 2009 | 1 Comment

HVAC system is not suppling enough fresh air. Is there a tool or device to measure air exchange rate in a specific building area or room?

Read More...

What bolts need to be removed to get the hvac housing off a 2001 dodge ram 1500?

By on Thursday, December 10th, 2009 | 1 Comment

I have removed every visible bolt from under the hood and under the dash. I have removed the bracket in the middle floor board on the airbag computer. I have detached all lines that run into the hvac housing, but the housing will not move! Are there any on the driver’s side that need removed? [...]

Read More...

HVAC Amp Draw

By on Thursday, December 10th, 2009 | 25 Comments

I explain how I use my multimeter to read the amp draw on a compressor. The guy in my intro that wears the pink shirt and wig is edbassmaster. You can check him out at: www.youtube.com The music was played and composed by Champagne Millionaire. You can check him out at: profile.myspace.com

Read More...

How do I repair a furnace duct hole?

By on Thursday, December 10th, 2009 | 2 Comments

I tried adding a humidifier to the duct attached to the furnace. I cut the hole too large and broke the humidifier. I’ve given up and just want to patch the hole. What’s the best approach? The hole is approximately 9″ x 9″.

Read More...

Anyone with furnace repair experience?

By on Thursday, December 10th, 2009 | 1 Comment

My furnace has a high pitched whine when it operates. It is coming from the impeller near the bleeder screw where the oil enters. There doesn’t seem to be a spot to lubricate it. This furnace is only 5 years old. What do I need to do?

Read More...

What is the best place in the kansas city area to call for Air Conditioning and Heating or Furnace repair?

By on Thursday, December 10th, 2009 | 4 Comments

I either need it fixed or replaced i need a good dependable company in the kansas city area and for a good price..

Read More...
« Older Entries
Newer Entries »